Datasheet

Point Laser Levels
Plumb
5
Plumb
The Product can send plumb marks up, down, or
cantilevered over the edge of a building or shaft opening.
To identify new plumb marks
on a ceiling or roof:
1. Place a cross mark on the point to be transposed.
2. Center the down laser over the cross mark. See
Fig
ure 3.
3. Place a mark at the point where the up laser intersects
th
e target area.
To identify new plumb marks on a floor, repeat the steps
a
bove but interchange the down and up lasers.
Note
Use the floor stand with the Product to increase the
sigh
t angle of down laser.
Figure 3. New Plumb Mark