User Manual

Industrial ScopeMeter®

Scope and Meter Mode

AC Coupling

Use AC-coupling to observe a small ac signal that rides

on a dc signal.

To select ac-coupling on input A:

1. Push  to open the Scope and Meter button bar.

2. Push 3 to open the INPUT SETTINGS menu.

3. Use YZ to highlight the Coupling as AC.

4. Push  to make the change.

5. Push 4 to exit the menu.

Waveform Trigger

The trigger tells the Test Tool when to start the waveform

trace. You can:

• select which input signal to use

• select which edge this should occur

• define the condition for a new update of the

waveform

The bottom line of the waveform area identifies the trigger

parameters in use. Trigger icons on the screen indicate

the trigger level and slope.

Note

The trigger settings are fixed for 3-phase power

measurements.

Set Trigger Level and Slope

For quick operation, use  to automatically trigger on

nearly all signals.  toggles between the Auto and

Manual mode. The current operating mode is shown in

the Information Area.

To optimize trigger level and slope manually:

1. Repeatedly push  until all menus and

secondary button bars close.

2. Push 2 to enable and use WXYZ to set the

Trigger level and slope adjustment.