Datasheet
TECHNICAL DATA
Fluke 710 mA Loop Valve Tester
Smart Control Valve Testing is now easier than ever
The Fluke 710 Valve Testing Loop Calibrator is designed to enable
users to perform quick, easy tests on HART smart control valves.
Featuring built-in test procedures and an intuitive user interface, the
710 allows users to quickly and easily perform valve tests, while the
valve test quick-check results provide at-a-glance diagnostics help
you make maintenance decisions faster than ever. The valve health
quick-check results let you know whether your valve is in good,
marginal or in bad operating condition so you can quickly decide
whether additional maintenance is necessary.
Valve testing and HART communication in a precision
loop calibrator
With the 710 Valve Testing Loop Calibrator’s built in HART
communication function, users can source a 4-20 mA signal to cause
the smart control valve to move, while simultaneously interpreting
the valve’s HART feedback signal to determine whether the valve is
moving to the expected position. In addition to positional information,
the measured pressure delivered from the valve’s internal I/P (which
moves the valve) can be determined through the HART communication
protocol.
The 710 has built-in test procedures that automatically increase
and change the mA signal while monitoring the HART position and
pressure feedback from the control valve, giving you a better overall
picture of valve health at the simple push of a button.
Pre-configured valve tests, at-a-glance answers
Valve test routines built into the 710 include:
• Manual testing; manually change the mA signal and view the
HART position and pressure variable information
• Full range ramping of the mA signal from 4 to 20 to 4 mA while
recording the 0-100-0% position, or the pressures applied that
move the valve from 0-100-0%
• Stepping the mA signal on the input to the valve in steps and
evaluating the valves response to the mA input changes
• Speed tests to determine how fast the valve can open or close
• Bump and partial stroke tests that help test valves over a portion
of their range so they can be tested in a live process
KEY VALVE TESTING FUNCTIONS
Valve signature test, speed test, step test,
manual test, bump/partial stroke test
KEY MA LOOP CALIBRATOR
FUNCTIONS
mA source, mA simulate, mA read, mA
read/loop power, and volts read
VALVETRACK™ SOFTWARE
Enables upload to a PC for further in-depth
analysis of valve measurements that are
logged and recorded to memory