Information

ManualsBrandsFLUKE ManualsTest EquipmentNetwork diagnostics 3-phase Data logger 1738/EU-GOLD-G

Manual Supplement

Manual Title: 1736/1738 Users Supplement Issue: 3

Print Date: September 2015 Issue Date: 8/18

Revision/Date: 1, 1/17 Page Count:

This

supplement contains information necessary to

ensure the accuracy of the above manual.

Summary of content (7 pages)

PAGE 1
Manual Supplement Manual Title: 1736/1738 Users Print Date: September 2015 Revision/Date: 1, 1/17 Supplement Issue: 3 Issue Date: 8/18 6 Page Count: This supplement contains information necessary to ensure the accuracy of the above manual. ©2017-2018 Fluke Corporation. All rights reserved.
PAGE 2
1736/1738 Users Manual Supplement Change #1, 381 On the Cover, add the  Symbol. On page 4, add the following to the Symbols table: Conforms to the Appliance Efficiency Regulation (California Code of Regulations, Title 20, Sections 1601 through 1608), for small battery charging systems.
PAGE 3
1736/1738 Users Manual Supplement On page 6, replace Figure 1 with: 3 2 4 1 5 6 hcf069.eps Figure 1.
PAGE 4
1736/1738 Users Manual Supplement Change #3, 595 On page 16, replace the Measurement Line Power Source section with: Measurement Line Power Source: XWWarning To prevent injury, do not touch the metal parts of one test lead when the other is still connected to hazardous voltage. WCaution To prevent damage to the Product, make sure the measured voltage does not exceed the input rating of the power supply. 1. 2. 3. 4. 5. 8/18 Attach the power supply to the Logger.
PAGE 5
1736/1738 Users Manual Supplement  For measurement connection to the Logger (see Figure 7A): X OK Figure 7A: Measurement connection to the Logger 8/18 4
PAGE 6
1736/1738 Users  6. 8/18 Manual Supplement To supply power to the Logger from installations with neutral voltage (see Figure 7B): Figure 7B: Measurement with neutral voltage and supplying instrument power. Note On single-phase systems, use the set of 1.5 m test leads (item 8 in Figure 7). Connect the voltage inputs to the test points. The Logger automatically turns on and is ready to use in <30 seconds.
PAGE 7
1736/1738 Users  Manual Supplement To supply power to the Logger from installations without neutral voltage (see Figure 7C): Figure 7C: Measurement without neutral voltage and supplying instrument power. Note On single-phase systems, use the set of 1.5 m test leads (item 8 in Figure 7). 7. Connect the voltage inputs to the test points. The Logger automatically turns on and is ready to use in <30 seconds.