User manual

Using The Recorder Functions
Recording Scope Waveforms In Deep Memory (Scope Record)
2
43
Using Triggering to Start or Stop Scope Record
To record an electrical event that causes a fault, it might
be useful to start or stop recording on a trigger signal:
Start on trigger to start recording; recording stops when
the deep memory is full
Stop on trigger to stop recording.
Stop when untriggered to continue recording as long as
a next trigger comes within 1 division in view all mode.
To set up the test tool, continue from step 3 of the
previous section:
4
F1
Stop recording to unlock the
OPTIONS… softkey
5
F2
Open the RECORDER OPTIONS
menu.
6
ENTER
Jump to the Mode: field, select
On Trigger… to open the START
SINGLE SWEEP ON TRIGGERING
menu.
7
ENTER
Select one of the Conditions:
and accept the selection.
During recording samples are continuously saved in deep
memory. The last twelve recorded divisions are displayed
on the screen. Use View All to display the full memory
contents.
Note
To learn more about the Single Shot trigger
function, see Chapter 4 “Triggering on
Waveforms”.