User manual

Using the Scope and Meter
Making Automatic Meter Measurements
1
21
3
ENTER
Select on A. Observe that the
highlight jumps to the present
measurement.
4
ENTER
Select the A dc… measurement.
5
ENTER
Select a current probe sensitivity
that matches the connected
current probe (see Adjusting the
Probe Type Settings on page 16.)
You will see a screen like in Figure 9.
Figure 9. Meter Screen
Making Relative Meter Measurements
A relative measurement displays the present
measurement result relative to a defined reference value.
The following example shows how to perform a relative
voltage measurement. First obtain a reference value:
1
METER
Display the METER key labels.
2 Measure a voltage to be used as
reference value.
3
F2
Set RELATIVE to ON. (ON is
highlighted.) This stores the
reference value as reference for
subsequent measurements.
Observe the ADJUST REFERENCE
soft key (F3) that enables you to
adjust the reference value (see
step 5 below).
4 Measure the voltage to be
compared to the reference.