User manual

Safe Use of Li-ion battery pack

Whenever it is likely that safety has been impaired, the

product must be turned off and disconnected from the line

power. The matter should then be referred to qualified

personnel. Safety is likely to be impaired if, for example,

the product fails to perform the intended measurements or

shows visible damage.

Safe Use of Li-ion battery pack

The battery pack Fluke model BP291 (52 Wh) has been

tested in accordance with the UN Manual of Tests and

Criteria Part III Subsection 38.3 (ST/SG/AC.10/11/Rev.3)

– more commonly known as the UN T1..T8 – tests, and

have been found to comply with the stated criteria. The

battery pack has been tested acc. to EN/IEC62133. As a

result they can be shipped unrestricted internationally by

any means.

Recommendations to safe storage of battery pack.

• Do not store battery packs near heat or fire. Do not

store in sunlight.

• Do not remove a battery pack from its original

packaging until required for use.

• When possible, remove the battery pack from the

equipment when not in use.

• Fully charge the battery pack before storing it for an

extended period to avoid a defect.

• After extended periods of storage, it may be

necessary to charge and discharge the battery packs

several times to obtain maximum performance.

• Keep the battery pack out of the reach of children and

animals.

• Seek medical advise if a battery or part of it has been

swallowed.