User's Manual

27 II/28 II Users Manual Supplement
2/13 1
Change #1
On page 2, under Warning, add:
 Measure a known voltage first to make sure that the Product operates correctly.
 Do not exceed the Measurement Category (CAT) rating of the lowest rated individual component
of a Product, probe, or accessory.
On page 5, Table 1, replace CAT III, CAT IV and add CAT II:
CAT III
Measurement Category III is applicable to
test and measuring circuits connected to
the distribution part of the building’s low-
voltage MAINS installation.
CAT IV
Measurement Category IV is applicable to test and
measuring circuits connected at the source of the
building’s low-voltage MAINS installation.
CAT II
Measurement Category II is applicable to
test and measuring circuits connected
directly to utilization points (socket Outlets
and similar points) of the low–voltage
MAINS installation.
Change #2, 63409, 64064, 64649
On page 5, add the following to the Symbols Table:

Conforms to relevant South Korean EMC Standards.