User's Manual

USB Drivers for Fluke 1760 Power Quality Analyzer

Connecting the Power Quality Analyzer and PC

Plug the USB cable into the USB port of your computer.

Wait approximately 1 minute. Windows XP needs this time to assign a valid IP address to

the network interface.

Note

Make sure the "Alternate Configuration" option is set to "automatic" in the

"Internet Protocol (TCP/IP) properties" settings for your USB virtual

network adapter.

Plug the other end of the cable into the 1760. Watch the LED next to the CF card slot

while connecting the USB cable.

If the LED is on then the USB link cable was successfully detected and activated. If the

LED remains dark then disconnect the cable, wait 3 seconds and try again.

Selecting the Analyzer

Launch PQ Analyze on your PC.

From the PQ Analyze main menu, select Transfer>Fluke 1760>Search Devices

ets007.bmp

Use the down arrow to select the USB Virtual Network Adapter and press Search.