User's Manual

Manual Supplement 1760 Users
2 2/14
Change #2, 67378, 67383
On page 1-3, in the Symbols table, replace the CAT II, III, IV entires with:

Conforms to relevant South Korean EMC Standards.
CAT II
MEASUREMENT CATEGORY II is applicable to test and measuring circuits
connected directly to utilization points (socket outlets and similar points) of the low-
voltage MAINS installation.
CAT III
MEASUREMENT CATEGORY III is applicable to test and measuring circuits
connected to the distribution part of the building’s low-voltage MAINS installation.
CAT IV
MEASUREMENT CATEGORY IV is applicable to test and measuring circuits
connected at the source of the building’s low-voltage MAINS installation.
On page 1-4, replace Figure 1-1 with:
CAT IVCAT II CAT IIIO
Key
O Other circuits that are not directly connected to MAINS
CAT II Measurement Category II
CAT III Measurement Category III
CAT IV Measurement Category IV
1-1.bmp
Figure 1-1. CAT
Under Safety Instructions, remove the first sentence.