User's Manual

ManualsBrandsFluke ManualsPower and Energy LoggersFluke 1760TR Basic

Manual Supplement



Manual Title: 1760 Users Supplement Issue: 4

Print Date: June 2006 Issue Date: 5/14

Revision/Date: 2, 5/10 Page Count: 4

This supplement contains information necessary to ensure the accuracy of the

above manual. This manual is distributed as an electronic manual on the

following CD-ROM:

CD Title: 1760

CD Rev. & Date: 5, 7/2010

CD PN: 2583518

Summary of content (5 pages)

PAGE 1
Manual Supplement Manual Title: Print Date: Revision/Date: 1760 Users June 2006 2, 5/10 Supplement Issue: Issue Date: Page Count: 4 5/14 4 This supplement contains information necessary to ensure the accuracy of the above manual. This manual is distributed as an electronic manual on the following CD-ROM: CD Title: CD Rev. & Date: CD PN: © 2011-2014 Fluke Corporation. All rights reserved.
PAGE 2
1760 Users Manual Supplement Change #1, 57261, 57516 On page 1-7, replace the first figure with: On page 5-3, under General Specifications, replace the Power Supply with: Power Supply Nominal 100 to 240 V ac, 50/60Hz, 100 to 350Vdc Power Supply Operating 83 to 264 V ac, 45 to 65 Hz, 100 to 375Vdc, 35W/70 VA On page 6-5, under Flexible Current Probes for AC, replace the Model No. Product No. column with: Model No. Product No.
PAGE 3
Manual Supplement 1760 Users Change #2, 67378, 67383 On page 1-3, in the Symbols table, replace the CAT II, III, IV entires with:  Conforms to relevant South Korean EMC Standards. CAT II MEASUREMENT CATEGORY II is applicable to test and measuring circuits connected directly to utilization points (socket outlets and similar points) of the lowvoltage MAINS installation.
PAGE 4
1760 Users Manual Supplement On page 1-8, replace Figure 1-3 with: 1 2 6 3 7 5 10 4 Grafikview.eps Figure 1-3. Top View On page 1-9, replace Table 1-2, with: Item Description  Mains connection  Mains switch  LED indicators  Ethernet connector  USB connectors  COM1 – serial port  Feature connector (GPS, DCF 77, COM2, alarms, etc.
PAGE 5
Manual Supplement 1760 Users Under  2 USB connectors, replace the Note with: Note A USB stick must not be pulled out while the USB LED flashes. This can cause permanent damage to the storage media. Only remove the USB stick while the USB LED is OFF or statically ON. Do not use the USB and data connection at the same time. Stored data can be erased by holding down the Reset button  while switching on the instrument. This may be useful if the memory is full and may also resolve connectivity issues.