User's Manual

PC Software for 1740 Series
PQ Log Feature Reference
23
Print whole measurement period
Opening a Data File
This menu item opens a saved Logger measurement data file.
To open a Logger data file:
1. Select the desired file in the "File/Open a data file" dialog box.
2. Select the evaluation period. This is important if the data was recorded for a long
period and a report according to European standard EN 50160 is required
(1 week period). This selection does not delete any data in the data file. It just
limits what data in the file you will be viewing.
Reopen a Data File
This menu option allows you to reopen a saved Logger measurement data file to select
another evaluation period.
Close the Data File
This menu option allows you to close the data file
Information about the Data File
This menu option displays information about the data file.
To enter information about the measurement:
1. Click the Text button. The data file screen, for entering/modifying specific text
for a finished measurement appears.
2. Click OK. Your text annotation is stored in the data file.
Note
The text is transferred to the ASCII file during the export function. In that
way, PQ Log passes information from the data file to the exported data file.
The Logger button shows all relevant information on the firmware and hardware of the
Logger that has been used for the logged data.
Print Document
This option prints the active analysis (of the active window). You can activate a screen by
clicking on the required window or you can select it from Window>Name of Window
menu. .
Setup Printer
This option opens the standard dialog box for printer settings.
Exporting Data
This option exports the selected measurement data to a file in the ASCII-format. This
option is active only in the analysis mode. Check the settings for the export before using
this option using Software Settings>Export menu.
1. Interval data: This option exports the parameters that are stored at the end of
each interval (normally after every 10 minutes).