Owners manual
1.Strip cable jacket.
Seven easy steps to use the JackRapid
2.Determine wiring scheme. Dress all
4 pairs (8 wires).
3.Insert jack in JackRapid front first with
IDC slots facing blades of JackRapid.
4.Ensure jack is completely and
securely inserted in jack holder bed
with IDC slots facing the blades.
5.Pull trigger completely until you hear
an audible "click".
6.Wires will be seated and cut for a
solid termination.
7.Release handle and remove jack
from JackRapid tool. Visually verify
proper termination.
1.Open tool handle and move lever
to pin #1 "down" position.
Six easy steps to change the blade
2.Angle handle, and insert pin one into
blade head first. Be sure to keep tool
handle in open position.
3.Make sure handle is open. Once
pin #1 has been inserted, slide pin
#2 into blade head.
1.Make sure handle is in open position.
Push handle and blade toward each
other.
2.Angle handle so that pin # 2 will slide
out first. Then slide out pin # 1.
IDC
Slots
Blades
Front
Move lever pin #1 to
"down" position
Open
Op
en
Op
e
n
Op
en
Pin #1
Pin #2
Pin #1
Pin #2
To attach blade head
To remove blade head
3.You have successfully removed the
blade head.
Open