Owners manual

1.Strip cable jacket.
Seven easy steps to use the JackRapid
2.Determine wiring scheme. Dress all
 4 pairs (8 wires).
3.Insert jack in JackRapid front first with
 IDC slots facing blades of JackRapid.
4.Ensure jack is completely and
 securely inserted in jack holder bed
 with IDC slots facing the blades.
5.Pull trigger completely until you hear
 an audible "click".
6.Wires will be seated and cut for a
 solid termination.
7.Release handle and remove jack
 from JackRapid tool. Visually verify
 proper termination.
1.Open tool handle and move lever
 to pin #1 "down" position.
Six easy steps to change the blade
2.Angle handle, and insert pin one into
 blade head first. Be sure to keep tool
 handle in open position.
3.Make sure handle is open. Once
 pin #1 has been inserted, slide pin
 #2 into blade head.
1.Make sure handle is in open position.
 Push handle and blade toward each
 other.
2.Angle handle so that pin # 2 will slide
 out first. Then slide out pin # 1.
IDC
Slots
Blades
Front
Move lever pin #1 to 
"down" position
Open
Op
en
Op
e
n
Op
en
Pin #1
Pin #2
Pin #1
Pin #2
To attach blade head
To remove blade head
3.You have successfully removed the
 blade head.
Open