Quick Start Guide

3
Battery Installation, Life, and Status
the output is continuous. It blinks if the output is
modulated. Use these modes if using the source with a
meter other than a SimpliFiber Pro meter.
Also enables or disables auto power-off. See page 6.
I I: Selects FindFiber mode. The ID LED lights if the source
is in FindFiber mode. See page 9.
J The LOW BATTERY LED blinks continuously if the battery is
low. The LED blinks occasionally if auto power-off is
disabled. See page 6.
K Output port with SC adapter.
Battery Installation, Life, and Status
ffk02.eps
Device Battery Life
1
Low Battery Indicator
Meter >50 hours (blinks continuously)
Multimode source 40 hours
LOW BATTERY LED blinks
continuously
2
Singlemode sources 30 hours
FindFiber source >80 hours LED blinks continuously
1. Typical. See the Users Manual.
2. The LOW BATTERY LED blinks occasionally if auto power-off is
disabled. See page 6.
AA
IEC LR6
NEDA 15A
AA
IEC LR6
NEDA 15A
Note: Fluke Networks recommends alkaline batteries.