Instructions
Table Of Contents
- SimpliFiber Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- List of Figures
- Introduction
- Registration
- The Fluke Networks Knowledge Base
- Contacting Fluke Networks
- Safety Information
- Battery Installation, Life, and Status
- Meter and Source Features
- Display Features
- Setting User Preferences
- Continuous Wave/2 kHz Modes
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Detecting Active Fibers
- Locating Fibers
- Measuring Optical Power
- Measuring Loss
- Memory Functions
- Maintenance
- Options and Accessories
- Specifications
- Appendix A: How to Test Your Test Reference Cords
- Appendix B: Using Mandrels
- Appendix C: Fiber Test Method Names
- Appendix D: Loss Test Methods
- Index
SimpliFiber Pro Meter and Test Kits
Users Manual
62
Modified 1 Jumper Method
This section describes modified reference and test
connections that produce 1 jumper results. Use these
connections if you need 1 jumper results but do not have
connector adapters that match the connectors on the link.
This method lets you connect to the link without disturbing
the source’s output connections after setting the reference.
Figure D-4 shows reference and test connections for one
fiber in a duplex cable with LC connectors.