Instructions
Table Of Contents
- SimpliFiber Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- List of Figures
- Introduction
- Registration
- The Fluke Networks Knowledge Base
- Contacting Fluke Networks
- Safety Information
- Battery Installation, Life, and Status
- Meter and Source Features
- Display Features
- Setting User Preferences
- Continuous Wave/2 kHz Modes
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Detecting Active Fibers
- Locating Fibers
- Measuring Optical Power
- Measuring Loss
- Memory Functions
- Maintenance
- Options and Accessories
- Specifications
- Appendix A: How to Test Your Test Reference Cords
- Appendix B: Using Mandrels
- Appendix C: Fiber Test Method Names
- Appendix D: Loss Test Methods
- Index
Specifications
35
Multimode Source
LED: dual 850 nm/1300 nm
850 nm: ±30 nm
1300 nm: ±20 nm
850 nm: 50 nm (typical)
1300 nm: 170 nm (maximum)
850/1300 nm: -20 dBm
±0.1 dB over 8 hours
Yes. Can be enabled or disabled by the user.
Fixed SC
Yes. Fixed at ID 1.
CW (continuous wave), 2 kHz modulated, auto-wavelength
Emitter type
Central wavelength
Spectral width (FWHM)
Minimum output power
Power output stability
1
Auto dual-wavelength switching
Optical output connector
FindFiber ID generation
Modes
1. 23°C ±2°C, after 5 minutes of warm-up time.