Instructions
Table Of Contents
- SimpliFiber Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- List of Figures
- Introduction
- Registration
- The Fluke Networks Knowledge Base
- Contacting Fluke Networks
- Safety Information
- Battery Installation, Life, and Status
- Meter and Source Features
- Display Features
- Setting User Preferences
- Continuous Wave/2 kHz Modes
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Detecting Active Fibers
- Locating Fibers
- Measuring Optical Power
- Measuring Loss
- Memory Functions
- Maintenance
- Options and Accessories
- Specifications
- Appendix A: How to Test Your Test Reference Cords
- Appendix B: Using Mandrels
- Appendix C: Fiber Test Method Names
- Appendix D: Loss Test Methods
- Index
SimpliFiber Pro Meter and Test Kits
Users Manual
28
Figure 12. Loss Measurement Display
ffl17.eps
The wavelength being measured.
Indicates the meter is in auto wavelength mode.
The loss measurement. If the loss measurement is blinking,
the loss is negative and less than -1.0 dB. See “If Loss is
Negative” on page 29.
The reference value.
Pressing SET REF saves the measured power level as the
reference.
Pressing SAVE saves the measurement. If the source was
automatically switching wavelengths, the meter saves
measurements for all wavelengths in one record.
A
C
E
B
D
F