Instructions
Table Of Contents
- SimpliFiber Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- List of Figures
- Introduction
- Registration
- The Fluke Networks Knowledge Base
- Contacting Fluke Networks
- Safety Information
- Battery Installation, Life, and Status
- Meter and Source Features
- Display Features
- Setting User Preferences
- Continuous Wave/2 kHz Modes
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Detecting Active Fibers
- Locating Fibers
- Measuring Optical Power
- Measuring Loss
- Memory Functions
- Maintenance
- Options and Accessories
- Specifications
- Appendix A: How to Test Your Test Reference Cords
- Appendix B: Using Mandrels
- Appendix C: Fiber Test Method Names
- Appendix D: Loss Test Methods
- Index
SimpliFiber Pro Meter and Test Kits
Users Manual
22
Using the Min/Max Function
The Min/Max function shows the minimum and maximum
power levels measured for each wavelength.
To enable the Min/Max function:
1
On the meter, hold down for 4 seconds to enter
setup mode.
2
Press so that appears.
3
Press until POWER appears; then press again to
see the Min/Max measurements (Figure 9).
The meter shows the minimum (Min) and
maximum
(Max) power levels measured since you entered the
power measurement mode at the selected wavelength.
4
To switch between minimum and maximum values,
press
.
Notes
The meter records new minimum and maximum
valu
es each time the wavelength changes.
You cannot save power measurements or set the
reference if Min
or Max appear on the display.
ffl14.eps
Figure 9. Power Measurement Display with Min/Max
Function Enabled