Instructions
Table Of Contents
- SimpliFiber Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- List of Figures
- Introduction
- Registration
- The Fluke Networks Knowledge Base
- Contacting Fluke Networks
- Safety Information
- Battery Installation, Life, and Status
- Meter and Source Features
- Display Features
- Setting User Preferences
- Continuous Wave/2 kHz Modes
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Detecting Active Fibers
- Locating Fibers
- Measuring Optical Power
- Measuring Loss
- Memory Functions
- Maintenance
- Options and Accessories
- Specifications
- Appendix A: How to Test Your Test Reference Cords
- Appendix B: Using Mandrels
- Appendix C: Fiber Test Method Names
- Appendix D: Loss Test Methods
- Index
Measuring Optical Power
21
Figure 8. Power Measurement Display
ffl20.eps
The wavelength being measured.
Indicates the meter is in auto wavelength mode.
The power measurement. To change the measurement unit
see page 10.
Pressing SET REF saves the measured power level as the
reference and switches the meter to loss measurement
mode.
Pressing SAVE saves the measurement. If the source was
automatically switching wavelengths, the meter saves
measurements for all wavelengths in one record.
A
C
D
B
E