Instructions
Table Of Contents
- SimpliFiber Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- List of Figures
- Introduction
- Registration
- The Fluke Networks Knowledge Base
- Contacting Fluke Networks
- Safety Information
- Battery Installation, Life, and Status
- Meter and Source Features
- Display Features
- Setting User Preferences
- Continuous Wave/2 kHz Modes
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Detecting Active Fibers
- Locating Fibers
- Measuring Optical Power
- Measuring Loss
- Memory Functions
- Maintenance
- Options and Accessories
- Specifications
- Appendix A: How to Test Your Test Reference Cords
- Appendix B: Using Mandrels
- Appendix C: Fiber Test Method Names
- Appendix D: Loss Test Methods
- Index
SimpliFiber Pro Meter and Test Kits
Users Manual
14
Changing the Connector Adapter
You can change the meter’s connector adapter to connect
to SC, ST, and LC fiber connectors. Additional adapter styles
may be available. Check the Fluke Networks web site for
updates.
Caution
Cover all connectors with dust caps when not in
use.
Store extra connector adapters in the canisters
provided.
Do not touch the photodiode lens (see Figure 4).
Do not overtighten the adapter or use tools to
tighten the adapter.
To install a connector adapter, refer to Figure 4 and do the
foll
owing:
1
Locate the slot in the meter’s connector and the key on
the adapter ring.
2
Holding the adapter so it does not turn in the nut,
align the adapter's key with the meter connector's slot
and slide the adapter onto the connector.
3
Screw the nut onto the meter connector.