Instructions
Table Of Contents
- SimpliFiber Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- List of Figures
- Introduction
- Registration
- The Fluke Networks Knowledge Base
- Contacting Fluke Networks
- Safety Information
- Battery Installation, Life, and Status
- Meter and Source Features
- Display Features
- Setting User Preferences
- Continuous Wave/2 kHz Modes
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Detecting Active Fibers
- Locating Fibers
- Measuring Optical Power
- Measuring Loss
- Memory Functions
- Maintenance
- Options and Accessories
- Specifications
- Appendix A: How to Test Your Test Reference Cords
- Appendix B: Using Mandrels
- Appendix C: Fiber Test Method Names
- Appendix D: Loss Test Methods
- Index
SimpliFiber Pro Meter and Test Kits
Users Manual
4
Repair the Product before use if the battery leaks.
Replace the batteries when the low battery
indicator shows to prevent incorrect
measurements.
Turn off the Product and disconnect all test leads,
patch cords, and cables before you replace the
battery.
Be sure that the battery polarity is correct to
prevent battery leakage.
Do not disassemble or crush battery cells and
battery packs.
Do not put battery cells and battery packs near
heat or fire. Do not put in sunlight.
Caution
To avoid damaging fiber connectors, to avoid data
loss, and to ensure maximum accuracy of test
results:
Use proper cleaning procedures to clean all fiber
connectors before every use. Neglecting this step
or using improper procedures can cause unreliable
test results and may permanently damage the
connectors.
Cover all connectors with protective caps when not
in use.
Never connect the source to an active network.
Doing so can disrupt network operations.