Instructions
Table Of Contents
- SimpliFiber Pro Getting Started Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Accessing the Users Manual
- Safety
- Meter and Source Features
- Battery Installation, Life, and Status
- Meter Display Features
- Setting User Preferences
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Testing Your Test Reference Cords
- Detecting Active Fibers
- Locating Fibers
- Measuring Power
- Measuring Loss
- Memory Functions
- Contacting Fluke Networks
3
Battery Installation, Life, and Status
the output is continuous. It blinks if the output is
modulated. Use these modes if using the source with a
meter other than a SimpliFiber Pro meter.
Also enables or disables auto power-off. See page 6.
: Selects FindFiber mode. The ID LED lights if the source
is in FindFiber mode. See page 9.
The LOW BATTERY LED blinks continuously if the battery is
low. The LED blinks occasionally if auto power-off is
disabled. See page 6.
Output port with SC adapter.
Battery Installation, Life, and Status
ffk02.eps
Device Battery Life
1
Low Battery Indicator
Meter >50 hours (blinks continuously)
Multimode source 40 hours
LOW BATTERY LED blinks
continuously
2
Singlemode sources 30 hours
FindFiber source >80 hours LED blinks continuously
1. Typical. See the Users Manual.
2. The LOW BATTERY LED blinks occasionally if auto power-off is
disabled. See page 6.
AA
IEC LR6
NEDA 15A
AA
IEC LR6
NEDA 15A
Note: Fluke Networks recommends alkaline batteries.