Instructions
Table Of Contents
- SimpliFiber Pro Getting Started Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Accessing the Users Manual
- Safety
- Meter and Source Features
- Battery Installation, Life, and Status
- Meter Display Features
- Setting User Preferences
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Testing Your Test Reference Cords
- Detecting Active Fibers
- Locating Fibers
- Measuring Power
- Measuring Loss
- Memory Functions
- Contacting Fluke Networks
10
SimpliFiber Pro Getting Started Guide
ffl19.eps
Using FindFiber Mode to Locate Fibers
Measuring Power
The power measurement shows the optical power level
produced by a source such as an optical network interface card
or optical test equipment.
1
Clean the connectors on the link to be tested. Use fiber
optic solvent and optical-grade wipes or swabs to clean
connectors as described in the Users Manual.
2
On the meter, press until POWER appears.
3
Make the connections shown on page 11.
4
If the source’s AUTO LED is not on, press .
5
If you want the source to automatically switch wavelengths,
press
until the wavelength LEDs blink alternately. Or you
may press to switch wavelengths as needed.
6
To save the measurement, press SAVE.
ID #3
ID #4
ID #1
(multimode
source)
ID #5
Fiber links
Patch panel