Instructions
Table Of Contents
- SimpliFiber Pro Getting Started Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Accessing the Users Manual
- Safety
- Meter and Source Features
- Battery Installation, Life, and Status
- Meter Display Features
- Setting User Preferences
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Testing Your Test Reference Cords
- Detecting Active Fibers
- Locating Fibers
- Measuring Power
- Measuring Loss
- Memory Functions
- Contacting Fluke Networks
9
Locating Fibers
Locating Fibers
The FindFiber mode helps you identify links at patch panels.
To use FindFiber mode:
1
Connect the meter and a SimpliFiber source or one or more
FindFiber sources to the links as shown on page 10.
2
Turn on the meter and the source or FindFiber sources.
If you are using a SimpliFiber source, press on the
source.
To change the number transmitted by a FindFiber
source, turn the source off, hold down the power key
for about 4 seconds; then release the key when the
desired LED turns on.
3
On the meter, press until FindFiber
™
appears.
4
The meter indicates connectivity as follows:
Note
In power or loss mode, ID blinks if the meter is
connected to a FindFiber source or a source in ID mode.
Source Connected Number on Meter
SimpliFiber Pro multimode source
SimpliFiber Pro singlemode source
1310 nm /1550 nm
SimpliFiber Pro singlemode source
1490 nm/1625 nm
FindFiber source Number indicated by
the LED on the source
No continuity or incompatible
source connected