Instructions
Table Of Contents
- SimpliFiber Pro Getting Started Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Accessing the Users Manual
- Safety
- Meter and Source Features
- Battery Installation, Life, and Status
- Meter Display Features
- Setting User Preferences
- Auto Wavelength Mode
- Cleaning Connectors and Adapters
- Changing the Connector Adapter
- Testing Your Test Reference Cords
- Detecting Active Fibers
- Locating Fibers
- Measuring Power
- Measuring Loss
- Memory Functions
- Contacting Fluke Networks
6
SimpliFiber Pro Getting Started Guide
Setting User Preferences
For the meter:
1
To enter setup mode, hold down for 4 seconds.
2
To scroll through the setup items, press . To change
settings, press
.
3
To exit setup mode, press until the meter is in the
desired test mode.
For the source:
If auto power-off is enabled, the source turns off after 30
minutes if no keys are pressed.
To disable or enable auto power-off, hold down for 4
seconds.
If auto power-off is enabled, all LEDs turn on for 3 seconds.
If auto power-off is disabled, all LEDs blink for 3 seconds
and the LOW BATTERY LED blinks occasionally.
Meter Setup Item Choices
Enable or disable Min Max mode for power
measurements. See the Users Manual
mW µW dBm Select a unit for power measurements.
Turn the backlight off or on.
Select a time period for the meter to turn
off automatically if no keys are pressed.
The meter will not turn off if it is connected
to a source that is in AUTO or ID mode.
Dashes ( ) indicate auto power-off is
disabled.