Operation Manual

4
How to Do a FiberInspector Test
1. Power the Tester
Charge the battery if necessary. Connect the ac adapter to ac power and to
the adapter connector () shown in Figure 1. You can use the tester while
the battery charges.
2. Connect the FI-1000 Probe
With the tester off, connect the probe to the type A USB port on the side of
the tester. Then turn on the tester. Figure 2 shows the home screen for a
FiberInspector test.
3. Install the Correct Tip on the Probe
See Figures 3 and 4.
Figure 2. Panels on the Home Screen
I03.EPS
 To set up a project, tap the PROJECT panel.
 To change settings for the test, tap the test setup panel.
 To set up cable IDs, turn on Auto Save, and change the settings for the fiber
End, tap the Next ID panel.
 To enter the operator name, tap the Operator panel.
A
B
C
D