Operation Manual

DTX Series CableAnalyzer
Technical Reference Handbook
2-20
Step 7: Running the Test
7-1 Clean the connectors on the cabling to be tested.
7-2 Make the connections as shown in Figure 2-12.
7-3 Turn the rotary switch to AUTOTEST. If a copper adapter
is attached, verify that the media type is set to Fiber.
Press
J Change Media to change it if necessary.
7-4 Press P.
amd146a.eps
Figure 2-12. Testing a Fiber Link in Smart Remote Mode (1 Jumper Method)
Test reference cordsTest reference cords