Operation Manual

Tutorials on Setup and Test Procedures

Certifying Twisted Pair Cabling

2-11

Step 4: Viewing the Autotest Results

The Summary screen, shown in Figure 2-6, tells you if the

test results met the selected test limit. This screen also

shows a status for each measurement:

E: PASS

F: FAIL

i: The results are for informational purposes only. The

measurement is not required by the selected test

limit.

U: The measurement is within the tester’s accuracy

uncertainty range. See page 3-12 for details.

To see the results for an individual measurement, use

D to highlight the test; then press H.

If the test failed, press

J Fault Info. for a diagnosis of the

fault. Figure 2-6 shows a typical diagnostic screen. The Next

Fault softkey is available if the tester detected more than

one fault. See Chapter 6 for more information on

diagnosing faults.

See Chapter 3 for details on twisted pair test results.

amd119f.eps

Figure 2-6. Autotest Summary and Diagnostic Screens