Operation Manual

DTX Series CableAnalyzer
Technical Reference Handbook
2-6
Step 1: Checking the Battery Status and Verifying
Operation with Twisted Pair Adapters
You should check the tester and smart remote’s battery
status and verify all equipment is in good working order
before going to the job site.
1-1 Connect the main and remote testers using one of the
methods shown in Figure 2-3.
1-2 Turn the rotary switch to SPECIAL FUNCTIONS.
1-3 Use D to highlight Battery Status; then press
H. Press I when you are done.
1-4 Use D to highlight Self Test; then press H.
1-5 If fiber modules are installed in addition to twisted pair
adapters, select Mainframe.
1-6 Press Pto start the self test.
Note
You can also check the battery status by
connecting with channel adapters and a patch
cord or by connecting through a link.
amd16.6eps
Figure 2-3. Battery Status and Self Test Connections for
Twisted Pair Adapters
Permanent link
adapter
Channel
adapter
TEST
LOW BATTERY
TONE
TALK
FAIL
TEST
PASS
TALK
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3
TEST
LOW BATTERY
TONE TALK FAIL TEST PASS
TALK
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3
DTX-REFERENCE module