Operation Manual

DTX Series CableAnalyzer
Technical Reference Handbook
5-2
amd140.eps
Figure 5-1. Coaxial Reference Connections
Verifying Operation
1 Connect the main and remote testers as shown for
setting the reference in
Figure 5-1.
2 Turn the rotary switch to SPECIAL FUNCTIONS.
3 Use D to highlight Self Test; then press H.
4 Press P.
If the tester reports an error, refer to “If Something Seems
Wrong” on page 14-9.
Coaxial Test Settings
Table 5-1 describes the settings that apply to coaxial cabling
tests.
To access the settings, turn the rotary switch to SETUP, use
D to highlight Coax; then press H.
TEST
LOW BATTERY
TONE
TAL K
FAI L
TEST
PAS S
TALK
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3