Operation Manual

Certifying Coaxial Cabling
35
Autotest on Coaxial Cabling
1 Attach coaxial adapters to the tester and smart remote.
2 Turn the rotary switch to SETUP, then select Coaxial.
Set the following on the Coaxial tab:
 Cable Type: Select a list of cable types; then select
the cable type to be tested.
 Test Limit: Select the test limit required for the job.
The screen shows the last nine limits used. Press
 More to see other lists of limits.
3 Turn the rotary switch to AUTOTEST and turn on the
smart remote. Connect to the cabling, as shown in
Figure 19 or 20.
4
5 Press on the tester or smart remote. To stop the test
at any time, press .
6 The tester shows the Autotest Summary screen when
the test is complete (see Figure 21 on page 38). To view
results for a specific parameter, use   to
highlight the parameter; then press
.
7 To save the results, press . Select or create a cable ID;
then press  again.
Note
If you turn off the main or remote unit while the
two units are connected through coaxial adapters,
the unit will turn on again.