Manualshelf

Operation Manual

ManualsBrandsFluke networks ManualsOtherDTX-1500
21222324252627282930
DTX-1500 CableAnalyzer
Users Manual
16
The optional DTX-PLA001 universal permanent link
adapter has a removable personality module. These may
be changed to customize the adapter for different jack
configurations.
To change the personality module, do the following (refer
to Figure 8):
1
Ground yourself by touching a grounded, conductive
surface.
2
Remove the link interface adapter from the tester.
3
Use your fingers to unscrew the screw on the
personality module.
4
Store the module in its original, static protection bag.
5
Put the new module in place and tighten the screw
with your fingers.
Caution
Tighten the screw snugly with your fingers
only. Do not overtighten. Doing so can damage
the module or the end of the cable.
X74F.EPS
Figure 8. Changing the Personality Module on
Optional DTX-PLA001 Adapters
The optional DTX-PLCAL automated calibration kit lets you
calibrate your permanent link adapters to compensate for
physical changes that occur over time to the adapter’s
cable and other components. Contact Fluke Networks for
more information.