Operation Manual

DTX-1500 CableAnalyzer
Users Manual
4
Warning
To prevent possible fire, electric shock, or personal
injury:
 Read all safety information before you use the
Product.
 Carefully read all instructions.
 Do not connect the tester to telephony inputs,
systems, or equipment, including ISDN inputs.
Doing so is a misapplication of this product,
which could result in damage to the tester and
create a potential shock hazard to the user.
 Do not open the case. You cannot repair or
replace parts in the case.
 Do not modify the Product.
 Use only replacement parts that are approved by
Fluke Networks.
 Do not touch voltages > 30 V AC rms, 42 V AC
peak, or 60 V DC.
 Do not use the Product around explosive gas,
vapor, or in damp or wet environments.
 Use this Product indoors only.
 Always turn on the Product before connecting it
to a cable. Turning the Product on activates the
tool’s input protection circuitry.
 Do not connect the Product to voltages that are
higher than the maximum voltage rating for the
Product.
 For Products that have multiple connectors for
different types of tests on copper cabling,
disconnect unused test leads from the connectors
before you do a test.
 Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
 Do not use and disable the Product if it is
damaged.
 Do not use the Product if it operates incorrectly.
 Batteries contain hazardous chemicals that can
cause burns or explode. If exposure to chemicals
occurs, clean with water and get medical aid.
 Remove the batteries if the Product is not used
for an extended period of time, or if stored at
temperatures above 50 °C. If the batteries are not
removed, battery leakage can damage the
Product.