Operation Manual

Chapter 1: Get Acquainted
Safety Information
3
 Do not use the tester if it is damaged. Inspect the
tester before use.
 Do not open the case; no user-serviceable parts are
inside.
 Do not modify the tester.
 If this equipment is used in a manner not specified
by the manufacturer, the protection provided by the
equipment can possibly be impaired.
Caution
To prevent damage to the tester or cables under
test, to prevent data loss, and to make sure your
test results are as accurate as possible:
 Do not connect the tester to an active network.
Doing so causes unreliable test results, can disrupt
network operations, and can cause damage to the
tester.
 Connect to the adapters only plugs that are made
for Ethernet applications, such as RJ45, ARJ45, and
Cat 7 plugs. Other types of plugs, such as RJ11
(telephone) plugs, can cause permanent damage to
the jacks.
 To make sure your test results are as accurate as
possible, do the reference procedure every 30 days.
See “About Link Interface Adapters” on page 24.
 Connect the AC adapter or replace the battery as
soon as the low battery indication appears.
 Keep modules attached to the main and remote
Versiv units to give protection to the module
connectors.
 Do not remove the USB flash drive while the LED on
the drive flashes. Doing so can corrupt the data on
the drive.
 You can lose a USB flash drive, cause damage to it,
or accidentally erase the contents of the drive. Thus,
riešenia na presné meranie
http://www.elso.sk