Operation Manual

Chapter 4: Projects
About Next ID Sets
65
 First ID and Last ID: The first and last IDs in a set of sequential
IDs.
If you do not enter a Last ID when you make an ID set, the tester
will increment the First ID to make subsequent IDs.
Note
The tester does not increment symbols or
accented characters.
When you use an ID set that does not have a Last ID, the set
under IDs Untested on the CHANGE ID screen shows only the
next ID.
 Total IDs: The number of IDs in the set. This section does not
show for ID sets that do not have a Last ID.
 Select Media: Select Copper to use the ID set to save results
from tests on copper cable.
Note
If you select Fiber, the ID set will not be available
when you do a copper test.
 Tap IMPORT to use an ID set that you downloaded to the tester
from LinkWare software.
 Tap REVIEW to see the CABLE ID REVIEW screen, which shows
the ID set an the total number of IDs.
Note
The REVIEW button does not show if you do not
enter a Last ID.
 SAVE: To save the ID set, tap SAVE.
riešenia na presné meranie
http://www.elso.sk