User Manual

Checking the Hardware and Software Versions
15
Checking the Hardware and Software
Versions
You may need to check your tester’s hardware or
software versions before updating the software or if you
contact Fluke Networks about the tester.
1 Turn the rotary switch to SETUP.
2 Press
D to highlight Version Information; then
press H or J.
The Version screen shows the following:
• SN: Serial number
• SW: Software version
• HW: Hardware version
• HW Date: The date the tester’s operation was
last verified at a Fluke Networks service center.
Qualifying Cabling with the Autotest
The Autotest tells you if cabling will support a selected
application. If the cabling does not qualify for the
application, the Autotest’s fault information helps you
diagnose the problem.
You can save Autotest results to document the
installation.
The Autotest can qualify cabling for the following
applications:
• 10BASE-T, 100BASE-TX, and 1000BASE-T twisted pair
Ethernet service
• VoIP (voice over internet protocol)
• Firewire (1394b-S100) service over twisted pair
cabling
• Analog telephone service
• Wiremap for any application
• 75 Ω coaxial applications, such as cable television