User Guide
Table Of Contents
- CableIQ Getting Started Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Accessing the Users Manual
- Safety
- Controls
- Setting User Preferences
- Editing Text
- Connecting for Cabling Tests
- Results Icons
- Discovering Cabling Characteristics
- Qualifying Cabling with the Autotest
- Using the Toner
- Blinking a Port Light
- Testing for Continuity
- Using the Continuity Toner
- Locating Crosstalk and Impedance Faults
- Testing Speaker Cabling
- Replacing the Batteries
- Contacting Fluke Networks
Results Icons
5
Results Icons
The icons below appear on Autotest and Discover
screens.
The cabling qualifies for the application.
The cabling does not qualify for the
application.
Results are for informational purposes
only, not for qualification. The cabling
cannot be completely qualified for the
application because the wiremap results
are incomplete (wiremap adapter not
used).
Pair is open.
Pair is shorted.
Wiremap adapter or remote ID locator at
far end, with its number.
Bridge tap detected.
Hub, switch, or PC NIC card detected. Port
speeds are 10, 100, 1000 Mb/s.
Voltage detected. This may indicate an
active telephone circuit, ISDN line, or
Power over Ethernet (PoE) device.
The tester is connected to an active
telephone circuit.
A signal is present on the pair.
The tester cannot identify the termination.