Data Sheet

Intelligent wiremap
The CableIQ™ Tester’s “intelligent wiremap”
feature tests for length, shorts, split pairs,
or opens and displays with an intuitive
graphical interface where a fault is located.
Unlike other testers that just show a series
of numbers for a wiremap, the unit displays
an easy-to-read graph with distance to faults
proportional to the cable length. It also iden-
tifies breaks and shorts by pin, rather than
by pair. This dramatically reduces the time to
locate and troubleshoot a poorly terminated
jack, or a break in the middle of a cable.
Figure 5. CableIQ tester’s “intelligent wiremap” shows pin 6
open at far end of tested cable (130 feet/34 meters).
Telephone wire test
CableIQ tester’s “multi-map” is a break-
through feature for residential cable testing.
Smart cable identifiers give the unique ability
to wiremap star wiring configurations often
found in residential voice systems. Wiremap
faults and ID number (up to seven) of any
jack can be seen from the main unit, all
at once.
Figure 6. CableIQ tester’s “multi-map” shows wiremap and
ID# of up to seven voice outlets at once.
switch
F1 F2
EXIT TEST
ENTER
F1 F2
EXIT TEST
ENTER
computer
open
an
alog ph
on
e
security cam
er
a/
v
ide
o
10
100
1000
Gi
g
Mbps
ca
b
lin
g
ba
nd
wi
dt
h
For more information
For more information or to contact your
local Fluke Networks Representative,
call [phone]. Or send email
to info@flukenetworks.com.
N E T W O R K S U P E R V I S I O N
Fluke Networks
P.O. Box 777, Everett, WA USA 98206-0777
Fluke Networks operates in more than 50 countries
worldwide. To find your local office contact details,
go to www.flukenetworks.com/contact.
©
2006 Fluke Corporation. All rights reserved.
Printed in U.S.A. 2/2006 2548214 D-ENG-N Rev A