Quick Start Guide



Fiber Type: Select a fiber type that is correct for the type

you will test.



Test Limit: Select General Fiber Optic.



Reference Method: Select 1 Jumper Reference.



No. of Connectors/Splices: These settings are only for test

limits that use a calculated limit for loss. They are not

applicable to the General Fiber Optic limit.

2-4 To save the settings, tap SAVE on the TEST SETUP screen.

Figure 2. Panels on the Home Screen

HGP01.EPS



To set up a project, tap the PROJECT panel.



To change settings for the test or select a different test, tap

the test setup panel.



To set up cable IDs and turn on Auto Save, tap the Next ID

panel.



To enter the operator name, tap the Operator panel.



To set the reference and verify your test reference cords for

loss/length tests, tap SET REF.