Manual
Table Of Contents
- LinkIQ™
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Table of Contents
- Introduction
- Automatic Test Discovery
- Contact Fluke
- Safety Information
- Product Familiarization
- Main Menu
- Before a Test
- Cable Tests
- Switch Tests
- Switch Test Results
- Save a Test Result
- Results Menu
- Delete Test Results
- Upload Results to LinkWare PC
- Tests with MS-IE-Adapter Set
- Maintenance
- Product Specifications
LinkIQ
Users Manual
34
PoE Test Pass Example
Figure 7 shows an example of test results of a single signature PoE device that passes. See the
explanation of the results below the figure.
Item Description Function
Volt minimum
The minimum required volts the device needs to meet under load
per the IEEE 802.3 standard based on the SW negotiated power
class (
).
Volts under load
Measured voltage under load at reported power draw.
: Indicates the voltage meets the requirements for the SW
negotiated power class ().
: Indicates the voltage does not meet the requirements for
the SW negotiated power class (
).
Or,
The switch under test can deliver the HW negotiated power
class, but the switch cannot deliver the additional power to the
device required to meet the SW negotiated power class because
the maximum power which the switch can deliver is already in
use.
: Indicates the device does not support the voltage required
to meet the HW negotiated power class.
Tab le 14. Po E Test Res ults (con t.)