Manual
Table Of Contents
- LinkIQ™
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Table of Contents
- Introduction
- Automatic Test Discovery
- Contact Fluke
- Safety Information
- Product Familiarization
- Main Menu
- Before a Test
- Cable Tests
- Switch Tests
- Switch Test Results
- Save a Test Result
- Results Menu
- Delete Test Results
- Upload Results to LinkWare PC
- Tests with MS-IE-Adapter Set
- Maintenance
- Product Specifications
LinkIQ
Users Manual
24
Test Limit Failure
Ta b l e 1 0 shows a cable test that fails because of near end cross talk (NEXT).
Tab le 10. NEX T Fai lure
Item Description
The Product detected the Remote ID, and the wire map passed.
The wire map passes because:
The wires are all connected correctly on both the near and far ends for a
straight through cable. Allow Crossover can be on or off to test a straight
through cable.
The continuity of the shield is not included as part of the test. (Shield >
).
The test fails because the test limit is set to verify the cable can support a
2.5BASE-T (2.5G) data rate throughput.
The cable can support 10BASE-T (10), 100BASE-TX (100), and
1000BASE-T (1G) data rate throughputs.
The cable cannot support 2.5BASE-T (2.5G) data rate throughput.
1
NEXT
1
3
2