Manual
Table Of Contents
- LinkIQ™
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Table of Contents
- Introduction
- Automatic Test Discovery
- Contact Fluke
- Safety Information
- Product Familiarization
- Main Menu
- Before a Test
- Cable Tests
- Switch Tests
- Switch Test Results
- Save a Test Result
- Results Menu
- Delete Test Results
- Upload Results to LinkWare PC
- Tests with MS-IE-Adapter Set
- Maintenance
- Product Specifications
Cable+Network Tester
Cable Tests
21
Wire Map Screen Multiple Failures
Ta b l e 9 shows a wire map of a cable test that failed for multiple reasons.
Table 9. Multiple Failures
Item Description
Pairs 1,2 are the shortest pair of the cable and open at 43.1 m.
The Product detected the Remote ID, and the wire map failed. The wires are not
wired correctly based on the settings selected for the test.
The wire map shows how the cable is wired. The wire map passes or fails based
on the settings selected for the test. For this test, the settings are set to test:
A straight through cable (Allow Crossover can be on or off to test a straight
through cable).
The continuity of the shield on the cable (Shield > )
The test limit is set to ≥1000BASE-T (1G) to verify a 4-pair cable.
1
Wire Map
4
1
2
5
6
7
3