Manual
Table Of Contents
- LinkIQ™
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Table of Contents
- Introduction
- Automatic Test Discovery
- Contact Fluke
- Safety Information
- Product Familiarization
- Main Menu
- Before a Test
- Cable Tests
- Switch Tests
- Switch Test Results
- Save a Test Result
- Results Menu
- Delete Test Results
- Upload Results to LinkWare PC
- Tests with MS-IE-Adapter Set
- Maintenance
- Product Specifications
LinkIQ
Users Manual
18
4. Connect the other end of the patch cable into an RJ-45 jack or into an adapter that is
connected to the near end of the cable under test. Then, connect the Remote ID into an
RJ-45 jack or adapter that is connected to the far end of the cable under test.
Or,
Connect the Remote ID into an RJ-45 jack or into an adapter that is connected to the near
end of the cable under test. Then, connect the other end of the patch cable into an RJ-45
jack or into an adapter that is connected to the far end of the cable under test.
5. Tap AUTO TEST to do a test.
The results show on the display. See Ta b l e 8 .
6. To save the results, tap SAVE AS.... See Save a Test Result.
Cable Test Results
Ta b l e 8 shows examples of results of cable tests.