User Manual
Table Of Contents
- PRO3000 Users Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Introduction
- Safety Information
- Installing Batteries
- The PRO3000 Probe
- The PRO3000 Toner
- Tracing Cables
- Tracing Pairs
- SmartTone Positive Identification
- Checking Polarity
- Checking Continuity
- Using the RJ11 Modular Plug
- In-House Communications (Talk Battery)
- Replacement Parts and Accessories
- Registration
- Contacting Fluke Networks
- Specifications
4
PRO3000 Toner and Probe Users Guide
The P
RO3000 Probe has a 3.5 mm monaural earphone jack on its side.
When you connect the optional earphone, the speaker is muted and
you hear the tones in the earphone. The earphone lets you avoid
disturbing people nearby. A compatible earphone is available from
Fluke Networks.
When using the optional earphone, start with a low volume. Always
approach wires cautiously to avoid loud tones in the earphone.
Adjust the volume as necessary.
The probe tip is replaceable. If the tip is damaged, replace it with the
spare tip found inside the probe’s battery compartment.
To remove the tip, turn it counterclockwise a quarter turn and pull it
out. To install a new tip, insert it into the hole in the front of the
probe and turn it clockwise a quarter turn until it stops.
The PRO3000 Toner
The PRO3000 toner emits two distinctive tones: constant and
alternating. With the slide switch in the TONE position, press the
tone button once for the constant tone. Press the button again for
an alternating tone. The tone LED is constantly on or flashing to
match the toner mode. (see Figure 2).
Press the button again to turn off the toner. The tone LED turns off,
indicating that the toner is off.