User Manual
Table Of Contents
- PRO3000 Users Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Introduction
- Safety Information
- Installing Batteries
- The PRO3000 Probe
- The PRO3000 Toner
- Tracing Cables
- Tracing Pairs
- SmartTone Positive Identification
- Checking Polarity
- Checking Continuity
- Using the RJ11 Modular Plug
- In-House Communications (Talk Battery)
- Replacement Parts and Accessories
- Registration
- Contacting Fluke Networks
- Specifications
3
The PRO3000 Probe
Installing Batteries
WXWarning
To avoid electrical shock, turn the unit off and
disconnect its leads from any circuit before opening the
unit’s battery door.
Use only 9 volt alkaline batteries (not included). Open the battery
compartment with a screwdriver to insert a new battery. Properly
attach the connection wires and close the compartment. Do not over
tighten the screw.
The PRO3000 Probe
The PRO3000 probe is a highly sensitive inductive probe with
amplified speaker, which makes signals transmitted by the P
RO3000
toner audible. The non-metallic tip allows testing in distribution
blocks without disturbing other services (see Figure 1).
WXWarning
Though the tip is non-metallic, never touch the tip to
exposed power sources such as electrical outlets.
bff01.eps
Figure 1. PRO3000 Probe