User Manual
Table Of Contents
- PRO3000 Users Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Introduction
- Safety Information
- Installing Batteries
- The PRO3000 Probe
- The PRO3000 Toner
- Tracing Cables
- Tracing Pairs
- SmartTone Positive Identification
- Checking Polarity
- Checking Continuity
- Using the RJ11 Modular Plug
- In-House Communications (Talk Battery)
- Replacement Parts and Accessories
- Registration
- Contacting Fluke Networks
- Specifications
2
PRO3000 Toner and Probe Users Guide
WXWarning
When connecting to metallic network wires, handle
alligator clips by the insulated boot.
The maximum voltage allowed across the test leads is 60
Vdc in toner and polarity modes. Do not connect to
circuits carrying AC voltage in toner or polarity mode. Do
not connect to circuits carrying AC or DC voltage in
continuity mode.
Disconnect clips from any metallic connections before
performing any maintenance. Read all instructions
completely and understand possible hazards to the end
user if maintenance is not performed by authorized
service personnel.
Do not use the toner or probe if they are damaged.
Before you use the toner or probe, inspect the case. Look
for cracks or missing plastic. Pay particular attention to
the insulation surrounding the connectors.
If this product is used in a manner not specified by the
manufacturer, the protection provided by the product
may be impaired.