User Manual
Table Of Contents
- PRO3000 Users Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Introduction
- Safety Information
- Installing Batteries
- The PRO3000 Probe
- The PRO3000 Toner
- Tracing Cables
- Tracing Pairs
- SmartTone Positive Identification
- Checking Polarity
- Checking Continuity
- Using the RJ11 Modular Plug
- In-House Communications (Talk Battery)
- Replacement Parts and Accessories
- Registration
- Contacting Fluke Networks
- Specifications
1
Introduction
The PRO3000 Toner and PRO3000 Probe helps you identify cables,
wires, and wire pairs. You connect the P
RO3000 Toner to a line, then
trace and follow the signal with the P
RO3000 Probe.
Safety Information
The following IEC symbols are used either on the test set or in the
manual:
WXWarning
This product is certified for indoor use only.
To avoid electrical shock, do not use the toner or probe if
they are wet. If they get wet, let them dry for 24 hours
before use.
W
Warning: Risk of personal injury. See the manual for details.
Caution: Risk of damage or destruction to equipment or
software. See the manual for details.
X
Warning: Risk of electric shock.
.
Earth ground
P
Conformité Européenne. Conforms to relevant European
Union directives.
)
CAN/CSA-C22.2 No. 60950-1-03
CAN/CSA-C22.2 No. 1010.1-92 + CSA-C22.2 No. 1010.1B-97,
UL/ANSI 3111-1
~
Do not put circuit boards in the garbage. Dispose of circuit
boards in accordance with local regulations.