User's Manual

TiS10, TiS20, TiS40, TiS45, TiS50, TiS55, TiS60, TiS65
Users Manual
28
Auto Capture
The Auto Capture feature allows you to set the Imager to
capture and save an infrared image, or series of images,
automatically. Image capture can be triggered manually or
with an “apparent temperature” trigger. The temperature
trigger is set to start when a value is above or below a set
limit. Regardless of how the capture starts, you can set the
interval for when successive images are captured and
saved. You also can set the number of images that are
captured and saved. The upper limit on how many images
is dependent on the amount of storage memory available.
To set and operate the Auto Capture feature:
1. Go to Camera > Auto Capture.
2. Push 1 to start the capture sequence.
In the Auto Capture sub-menu, you will see these options:
• Start Capture: Executes the Auto Capture settings in
camera memory.
• Interval: Push W/X to select the number of
hours, minutes, or seconds as an interval between
images.
• Image Count: Push W/X to manually select a
number of images. Or, push the Maximum Memory
button to select the option that will continue capturing
and saving images until the chosen storage memory is
filled or battery power is depleted.
• Manual Trigger: When Manual Trigger is selected,
push 1 to start the automatic capture of a series of
images.
• Temp Trigger: Select Temp Trigger and then select
Set Temp Trigger to open the adjustment menu.
Note
The minimum interval available can be affected by
the file type and visible light camera settings
chosen by the user. Some combinations create
larger file sizes that take longer to capture and
save and create a higher minimum interval
compared to others.