User's Manual

TiX520, TiX560
Users Manual
40
How to Clean the Case
Clean the case with a damp cloth and a weak soap
solution. Do not use abrasives, isopropyl alcohol, or
solvents to clean the case or lens/window.
Battery Care
 Warning
To prevent personal injury and for safe operation
of the Product:
• Do not put battery cells and battery packs near
heat or fire. Do not put in sunlight.
• Do not disassemble or crush battery cells and
battery packs.
• Remove batteries to prevent battery leakage
and damage to the Product if it is not used for
an extended period.
• Connect the battery charger to the mains power
outlet before the Product or battery.
• Use only Fluke approved power adapters to
charge the battery.
• Keep cells and battery packs clean and dry.
Clean dirty connectors with a dry, clean cloth.
 Caution
To prevent damage, do not expose Product to
heat sources or high-temperature
environments such as an unattended vehicle
in the sun.
To get the best performance from the lithium-ion battery,
use the guidelines that follow:
• Do not store the Imager on the charger for more than
24 hours as reduced battery life may result.
• Charge the Imager for a two-hour minimum at six-
month intervals for maximum battery life. Without use,
the battery will self-discharge in approximately six
months. Batteries stored for long periods will need two
to ten charging cycles for full capacity.
• Always operate in the specified temperature range.
• Do not store the batteries in extreme cold
environments.
• Do not attempt to charge the batteries in extreme cold
environments.
  Caution
Do not incinerate the Product and/or battery.